RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-6
Print Process Errors
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Resolving a Card Not Fed Error (Cards will not feed off the Hopper)
Step Procedure
1 Review the following information.
Symptom: Cards will not feed at all.
Printer Error State: Card is not being detected by the Card TOF Sensor 11
seconds after the initiation of a print job causing the Printer to produce an
error
LCD Error Display: Card Not Fed
Driver Monitor Error Display: Unable to Feed Card
To Next Page
Loading...
