Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
6-103
Using the Flipper Smart Angle Offset Option
Use this option to change the Flipper angle relative to the default smart card loading position.
This is done in order to adjust travel to and from the Flipper and the Smart Card Docking
Module.
Step Procedure
1 Enter a negative value to decrease the amount of Flipper angular movement
from the home position to the smart card loading position.
Or
Enter a positive value to increase the amount of Flipper angular movement from
the home position to the smart card loading position.
(Maximum Adjustment Range: The maximum adjustment range is 5. 1 is
approximately 1 degree.)

Fargo DTC400 Specifications

General

Print Resolution	300 dpi
Connectivity	Ethernet (optional)
Dimensions	254 x 254 x 229 mm (10 x 10 x 9 in)
Weight	6.8 kg (15 lbs)
Print Technology	Dye-Sublimation / Resin Thermal Transfer
Card Capacity	100 cards (input hopper)
Card Sizes Accepted	CR80 (3.375" x 2.125")
Card Thickness	0.76 mm (30 mil)
Memory	32 MB RAM
Operating System Supported	Windows
Operating System Compatibility	Windows 7, 8, 10 (32-bit and 64-bit)
Print Area	Full bleed