Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
5-36
Specifying UDP Event logging
Follow this procedure to enable logging to a UDP Syslog program.
Step Procedure
1
Select the System Log link.
 The messages will be sent via UPD packets to the Syslog port (514) of
the specified host.
 It is up to the host program to listen to these messages for processing.
 A syslog host program is necessary to use this method, such as, Kiwi
Syslog Daemon or WinSysLog.
2 Select the link for the log name you want to view or configure (the default
choices are log1 or log2).
3
Select the UDP Syslog radio button.
4 Enter a valid IP address or domain name.
5
Select Submit.
6
Log in as a root User if you are so prompted. (Note: Any change of setting
will only be accepted after you have successfully logged in.)

Fargo DTC400 Specifications

General

Brand	Fargo
Model	DTC400
Category	Printer
Language	English