RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
5-47
Resetting to Default Settings
The Reboot page also allows the User to reboot the Ethernet Print Server into a default
settings mode. (Note: This simply restarts the Printer in a different state with the settings in
memory temporarily ignored.)
When the Default button is selected, the stored settings in the Printer’s memory are not
changed.
Step Procedure
1
Select the Administration link.
2 Log in as a root User (using the old password) if you are so prompted.
(Note: Any change of setting will only be accepted after you have
successfully logged in.)
3
Select the Reboot link.
4
Select the Default button.
5
Click the Yes button when prompted.
6 Wait for the Printer to reboot and display the home page.
To Next Page
Loading...
