RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-23
Resolving a Ribbon Out Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
ï‚· Symptom: Printer will not print.
ï‚· Printer Error State: The Ribbon Sensor has detected the End Of Ribbon
mark
ï‚· LCD Error Display: Ribbon Out
ï‚· Driver Monitor Error Display: Ribbon Out
2 Replace the Ribbon Cartridge
a. Press on the Resume button.