Fargo DTC400 - Resolving a no Ribbon Installed Error

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-24
Resolving a No Ribbon Installed Error
All Troubleshooting procedures assume that only factory-authorized supplies are in use in
the Printer.
Step Procedure
1 Review the following information.
 Symptom: Printer errors out as soon as it receives data from PC
 Printer Error State: The Printer RFID Sensor is not receiving a signal from
the Ribbon
 LCD Error Display: No Ribbon
 Driver Monitor Error Display: No Ribbon Installed