Fargo DTC400 - Page 19

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
2-5
Visual Security - Card Stock Part Numbers
All Visual Security Cards will be offered on the following Fargo Card Stocks only:
 P/NNo. 81754 Ultra Card
 P/NNo. 81762 Ultra Card III with hi-coercivity magnetic stripe
 P/NNo. 81763 Ultra Card III
Visual Security - Fargo Certified Overlaminates (Special Order in 50
quantity minimum)
 Part No. 82255: PolyGuard 1.0 mil for HoloMarkTM and VeriMarkTM Cards, Clear
 Part No. 82256: PolyGuard 1.0 mil for HoloMarkTM and VeriMarkTM Cards, High
Resolution Globe design hologram with "Secure" micro-text
Visual Security Card Stock - Tolerances
 Tolerance of base foil placement will equal +/- .010" from the nearest edges of the card
 Tolerance of layered foil will equal +/- .010"
VeriMarkTM - Application Specifications
VeriMarkTM foils will cover a dimensional area of 1.9 cm length x 1.3 cm height. The
exclusive areas are as follows:
 VeriMarkTM Card customers will be able to choose 1 of 8 pre-defined placements
(corners) via Printer Driver (4 positions) Landscape and (4 Positions) Portrait mode.
 VeriMarkTM foil placement will not interfere with card punch slots .
 Foil color base is silver; debossed impression is gold foil.
 VeriMarkTM foil placement will be located 0.4 cm from the edges of the card except for
the top two locations on portrait orientation cards (positions E & F). The foil will be
located 0.9 cm from the top of the card and 0.4 cm from the sides of the card.