RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
6-80
Selecting the Defined Area(s) function (Front and Back options)
To define an area, refer to the following steps:
Step Procedure
1
Click on the Defined Area(s) check box. (Note: This will activate the card grid
in the upper half of the window. It is through this card grid that up to five areas
can be defined.)
When the card grid is first activated, a small square will appear at its default
size of .2" x .2" / 5mm x 5mm and at its default location in the lower left-hand
corner (0,0). This square represents the first defined area.
(Note: Changing the orientation of the card in the Card Tab will change the
appearance of this Tab.)
To Next Page
Loading...
