Fargo DTC400 User Manual

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC400 Card Printer/Encoder User Guide (Rev. 2.2)
4-15
Resolving the Mag Verify Error (continued)
Step Procedure
2 Check to ensure that the cards are loaded with the Magnetic Stripe facing Up
and towards the front of the Printer.
3
a. Press on the Resume button.
b. If the error continues continue to step 4
4 Verify the Driver settings if cards are loaded properly. See the Using the
Magnetic Encoding tab (DTC400) procedure.
5 Verify that data is being encoded to the Magnetic Stripe.
a. Clear any Error Messages from the LCD by unplugging the Printer and
reapplying power.
b. Remove the failed card.
c. Use a Magnetic Stripe reader or magnetic developer spray to determine if
data is being written to the Magnetic Stripe.
d. If data is not being written to the Magnetic Stripe,
 Open the front cover.
 Remove the Magnetic Module cover screw.
 Remove the Magnetic Module cover.
 Verify that the Magnetic Module is seated securely into the Magnetic
Module docking station.
e. If the Magnetic Module is properly seated, replace the magnetic head (as
needed). (Note: See the current DTC400 User Guide for related
instructions in the Parts Replacement Section.)
f. If data is being written to the Magnetic Stripe, the Magnetic Offset may
need to be adjusted. See the Using the Mag Top of Form Option
procedure.

Fargo DTC400 Specifications

General

Brand	Fargo
Model	DTC400
Category	Printer
Language	English