FARO
®
Laser Scanner Manual
147
Chapter 9: Maintenance
5. Clean the mirror module (analogue: sensor cover) by rinsing with water or
diluted neutral soap solution in oscillation motion.
1. Perform visual inspection of cleaning status.
2. Repeat the rinsing step until contamination is significantly reduced or even
removed.
3. Wait for the optics to dry.
4. Turn laser scanner into upright (normal) position and ensure stable
placement. For example, place scanner on a table or transport box.
Alternatively, use tripod for mounting.
5. Proceed with Wet Cleaning by Tissue and Isopropyl Alcohol as a Cleaning
Fluid on page 138.
NOTICE
Damage to the scanner’s mirrors and lenses
Wait for the cleaning liquid to drain and dry off! DO NOT try
to dry the optics by wiping with tissue at this stage, as
residual contamination might still cause severe damaging to
the optics!
To Next Page
Loading...
