FARO
®
Laser Scanner Manual
82
Chapter 7: Controller Software
7.4.3 Operators
Information about which scanner operator has recorded which scans might be
useful for the person who is post-processing the scans; especially when there
are several scanner operators working on the same scan project.
You can assign scanner operators to the captured scans. To do this, select the
operator in the operators list. Create an operator profile first if it does not
already exist. The information about the selected operator is then stored in the
data of the next scans and can be accessed in SCENE during the post
processing of the scans.
Creating an Operator Profile
Figure 7-23: Operator Profiles list
To add a new operator profile, tap the
Add button. You can also add new
operator profiles by duplicating an existing operator profile. To do this, select
the operator profile you want to duplicate and tap the
Duplicate button. Tap
again to view a screen to enter the operator profile details.
NOTE: Outdoor: Far Distances is not available on all scanner
models. See See Differences between the scanners on page 12.
To Next Page
Loading...
