FARO
®
Laser Scanner Manual
39
Chapter 6: Getting Started
• Do not eject the memory card while it is busy.
• Take care that the memory card does not pop out and fall.
6.6 Switching the FARO Laser Scanner On
Pressing the scanner's On/Off button will start the boot process, which is
indicated by the scanner LEDs blinking blue. If power is supplied by the
battery and its charge state is too low to start the scanner, the scanner LEDs
will blink orange.
When the FARO Laser Scanner is ready, the LEDs will stop flashing and will
illuminate constantly blue, the Home screen of the scanner's controller
software will appear on the integrated touch screen.
Figure 6-9: Home Screen of the controller software
The FARO Laser Scanner can be operated to its full extent by simply tapping
the elements on the screen with your fingers. You can use a capacitive stylus
to navigate through the user interface.
6.7 Initial Scanner Settings
This chapter gives you a brief description on how to set up initial scanner
settings using the scanner's controller software on the integrated touch
screen. See
Controller Software for more information.
To Next Page
Loading...
