FARO
®
Laser Scanner Manual
32
Chapter 6: Getting Started
5. Charging starts automatically; the LED blinks and illuminate according to
the current charging state of the battery. For more information, see Power
Dock Battery Charger on page 25.
After charging, carefully press the charger interlock mechanism and remove
the battery out of position.
6.1.3 Tips for Using the Battery
• Charge the battery the day it is to be used or on the day before. A charged
battery that is unused, will gradually lose power over time.
• If the battery becomes exhausted quickly after being fully charged, replace
it with a new one.
• For best battery performance, an ambient temperature of 0°C (32°F) to
40°C (104°F) is recommended. In colder or warmer locations, battery
performance and operation time may temporarily decrease.
NOTICE
Check the Power Dock for damage before use. Check
especially that the safety clamps have not been damaged,
which can occur if the Power Dock falls when holding a
Power Block:
Undamaged safety clamp. Note the vertical position.
Damaged safety clamp. Note the slanted position.
Do not use a damaged Power Dock. Doing so may
damage the Power Block.
To Next Page
Loading...
