Faro Focus M 70 - Mechanical Safety; Transport

FARO
®
Laser Scanner Manual
19
Chapter 4: Safety Precautions
4.6 Mechanical Safety
4.7 Transport
The following precautions must be taken when transporting the laser scanner
equipment:
WARNING
Rotating Mirror
The mirror unit rotates with high speed while scanning and
for a short period after the scan. While the mirror is rotating
keep distance to the product and do not touch the rotating
mirror unit with your hands, fingers or any objects at the risk
of personal injury and damage to the FARO Laser Scanner.
CAUTION
General Use
The FARO Laser Scanner may only be used when set on a
flat and stable surface. Injuries may result if the FARO Laser
Scanner overturns. Only use equipment recommended by
FARO and follow the setup instructions in this manual or in
the manual of the manufacturer of the equipment.
Do Not Open the Housing
By opening the housing serious personal injury can be
caused and you can damage the product.
NOTICE
Cart Usage
If using a cart, move the setup with special care. Never move
the cart by pulling the power cables. Pushing or pulling of the
cart with too much force, sudden stops, or an uneven surface
can cause an upset of the FARO Laser Scanner.
Rotating Scanner
The FARO Laser Scanner will rotate clockwise up to 360
degrees when performing a scan. Ensure that the scanner
head of the FARO Laser Scanner can rotate freely and will
not hit any objects during the scan.
Replacement Parts
Only replacement parts authorized by FARO can be used
according to the instructions obtained from FARO. Do not
use parts which have not been supplied or recommended by
FARO.