Finsecur Baltic 512 TYPE A - Page 73

01-
ECMSI-NT002.Rev B40
Switching
detection points or zones on or off
I
During a shutdown, the sense buses remain energized. It is advisable to carry out a reset before putting
it back into service.
The
goal :make the detection point(s), area(s) inactive.
In
this position, all points or zones disabled are inoperative.
Screen Keyboard
manipulation
Mon 10/05/04 14:55:30
JULES
GESDE SCHOOL
BALTIC
512
SYSTEM IN STANDBY
BUS
POINTS ON/OFF
------------------------------
> 07 ADDRESS
----------
------------> 001
1.
Position yourself in the menu (level 2 access code);
1.2.2.
- SWITCHING ON/OFF POINTS
OR
1.2.3.
- ARMING/DISARMING ZONES
(Status:
Out of Service)
PREV NEXT
OK --> ES update
- +
Mon 10/05/04 14:55:30
2.
select the Bus or the address (only for points) using the A and B keys;
JULES GESDE SCHOOL
BALTIC
512
SYSTEM IN STANDBY
3.
press the OK key to activate or deactivate.
4.
exit the menu;
ENTIRE
ZONES ON/OFF ZONE
----------------------------
> 0001
(Status:
Out of Service)
PREV NEXT
OK --> ES update
- +
CONTROL
AND SIGNALING EQUIPMENT 512 POINTS BALTIC 512 TYPE A WALL OR RACK BOX
73