Finsecur Baltic 512 TYPE A - Main Power Supply; Secondary Supply; Audible and Visual Signaling; Testing of Automatic Detectors

01-
ECMSI-NT002.Rev B40
TESTS
Test of power supplies/audible and visual signals
main
power supply
Stock Report If anomaly then...
Switch on the ECS
→ Test the
ECS & CMSI mains
fuses;
→ Insert
the main and secondary power
supply fuses of the ECS, CMSI and AES/
EAES
The green "power
on" light is
on.
→ check
for the presence of
mains voltage.
Secondary supply
Shares Findings If anomaly
then...
→ The yellow “mains fault” indicator
lights up steadily;
1.Switch off the DHW main power supply
→ test
the ECS & CMSI battery
fuses;
2.
Remove the fuses from the ECS, CMSI
& AES/EAES main power supplies.
→ the
panel buzzer sounds
intermittently.
→ check the condition of the batteries.
Audible and visual signaling
Stock Report If
anomaly then...
While pressing
the key:
Ö
Hold
down the
"signalling test" button
the ECS indicator lights come on
steady;
contact
support
FINSECUR phone number:
08 99 70 24 68
Ö
Ö
the
panel buzzer sounds continuously; the display
indicates the software version of
the hardware.
Testing automatic detectors
Stock Report If the signage is different...
1.
Put the zones to be tested or the
entire ECS in test mode
→ The yellow "test" indicator lights
up
3.
MAINTENANCE
3.1.
TEST POSITION
→ Check :
Ö that the
detector or its zone is
in test mode;
→ The
detector's red indicator
flashes;
2.
Spray the test gas towards the
detector of a loop in test mode and
wait a few seconds.
Ö the detector base
wiring.
→ the
red “fire” indicator of the ECS
lights up.
→ Remove
the detector
from its base and check for the
appearance of a fault
Communication.
3.
Repeat this operation on all the
detectors.
Between
each test, rearm the system and wait for it to go back to standby (red indicator on the detector and red
"fire" indicator on the ECS off.
BALTIC
512 TYPE A WALL OR RACK BOX CONTROL AND SIGNALING EQUIPMENT 512 POINTS
76