This Fire Control panel can only be programmed using
the Software FireClass Console release 1.0 or higher.
Control panel FW ver. 1.0 or higher.
TYCO and BENTEL SECURITYsrl shall not assume
the responsibility for damage arising from improper ap
-
plication or use.
Installation of this Control panel must be carried out
strictly in accordance with the instructions described in
this manual and in compliance with the local laws and
bylaws in force.
The FC501-L,FC501-H and FC501-HK Fire Control pa
-
nels comply with the essential requirements of stan
-
dards EN54-2; EN54-4 and EN54-21.
Contents of the box and Unpacking
The control panel is contained in a carton box, inside
which are located:
Ø
the plastic cabinet (backplate and cover) with the
motherboard and the power supply Switching as
-
sembled.
Ø
The Quick Start Guide.
Ø
A transparent plastic bag inside:
- A CD-ROM with Installation and User manuals and
the FireClass software console to manage the pa
-
nel;
- Another transparent plastic bag containing:
-the KST thermal Probe;
- Two 3.9 kOhm resistors;
- a red and a black cable L = 300 mm with a faston
terminal to connect batteries;
- a black cable L = 300 mm with two faston terminal to
connect batteries. Proceed carefully to unpack the
contents and dispose of recyclable materials in ac-
cordance with the local law.
Recycling information
The manufacturer recommends that customers dispose of their used
equipment (panels, detectors, sirens, and other devices) in an environmen
-
tally sound manner. Potential methods include reuse of parts or whole pro
-
ducts and recycling of products, components, and/or materials.
Waste Electrical and Electronic Equipment (WEEE)
Directive
In the European Union, this label indicates that this product
should NOT be disposed of with household waste. It should be depo
-
sited at an appropriate facility to enable recovery and recycling.
NOTE- The FC501 Fire control panel can support several addressa
-
ble devices (Detectors, Modules, Manual call Points, etc). The pre
-
sent manual includes the instructions for their programming, but for
further information on those devices and their accessories, please vi
-
sit: www.fireclass.net, logging in the Reserved Area, under Installa
-
tion Manuals.
The manufacturer reserves the right to change the technical specifi
-
cations of these products without prior notice.
0051
BENTEL SECURITY s.r.l.
Via Gabbiano, 22 - Zona Ind. S. Scolastica
64013 Corropoli (TE) - ITALY
13
0051-CPR-0406 (FC501-L)
0051-CPR-0407 (FC501-H)
0051-CPR-0419 (FC501-HK)
EN 54-2:1997+A1:2006 EN 54-21
Control and indicating equipment for fire detection and fire alarm
systems for buildings with alarm transmission and fault warning
routing equipment.
EXPECTED OPTIONS
Fault signals from points
Dependencies on more than one alarm signal: type A and B
Delays to outputs
Disablement of addressable point
Test condition
Output to fire alarm device
EN 54-2 ESSENTIAL CHARACTERISTICS
Performance under fire conditions Passed
Response delay (response time to fire) Passed
Operational reliability Passed
Durability of operational reliability, Temperature resistance Passed
Durability of operational reliability, Vibration resistance Passed
Durability of operational reliability, Electrical stability Passed
Durability of operational reliability, humidity resistance Passed
EN 54-21 ESSENTIAL CHARACTERISTICS
Performance of transmission Passed
Operational reliability Passed
Durability of operational reliability, Temperature resistance Passed
Durability of operational reliability, Vibration resistance Passed
Durability of operational reliability, Electrical stability Passed
Durability of operational reliability, humidity resistance Passed
EN 54-4 ESSENTIAL CHARACTERISTICS
Performance of power supply Passed
Operational reliability Passed
Durability of operational reliability, Temperature resistance Passed
Durability of operational reliability, Vibration resistance Passed
Durability of operational reliability, Electrical stability Passed
Durability of operational reliability, humidity resistance Passed
0051
BENTEL SECURITY s.r.l.
Via Gabbiano, 22 - Zona Ind. S. Scolastica
64013 Corropoli (TE) - ITALY
13
0051-CPR-0408 (FC500IP in FC501-L/FC501-H/FC501-HK)
EN 54-21
Alarm transmission and fault warning routing equipment for fire
alarm systems installed in buildings.
EN 54-21 ESSENTIAL CHARACTERISTICS
Performance of transmission Passed
Operational reliability Passed
Durability of operational reliability, Temperature resistance Passed
Durability of operational reliability, Vibration resistance Passed
Durability of operational reliability, Electrical stability Passed
Durability of operational reliability, humidity resistance Passed
To Next Page
Loading...
