FISCHER DELTASCOPE DMP30 - Free-Running Mode Procedure; Scan Mode Procedure

18
DMP30 / DMP40
Technical Data
Applications
Metrological Features
Measurement acquisition
 Default: After each placement of the probe onto the surface, a measured read-
ing is automatically recorded
 Scan mode: While probe is moving over the surface the measured readings are
automatically recorded according to the defined time interval and number of
measurements.
Indication of measurement acquisition
 Audible by a short beep, can be disabled
 Visual by colored illuminated strip (green: measured value recorded)
 Haptic feedback by gauge vibration, can be disabled
 Limit violation: 2 short beeps, red illuminated strip and gauge vibration
 Measured reading between the limits: 1 short beep, green illuminated strip and
gauge vibration
Measurement performance
Measurement speed, measurement range, trueness etc. depend on connected
probe, you will find these data in the respective probe data sheet
DELTASCOPE
DMP30
ISOSCOPE
DMP30
DUALSCOPE
DMP40
SR-SCOPE
DMP30
 
 
Examples
Base material steel or iron (FE)
 Zn, Cr, Cu coating on steel or iron
(NF/FE)
 Paint, varnish, plastic coating on
steel or iron (NC/FE)
Base material electrically conductive (NF)
 Paint, varnish, plastic coating on
Al, Cu or Brass (NC/NF)
 Anodized coating on Al (NC/NF)