91
DMP30 / DMP40 Gauge settings
14.3 Signal settings – visual and audible signals
You can activate and deactivate the sound and light signals, as well as the gauge vi-
bration function for measured reading acquisition and specification limit violations.
To activate/deactivate the signals
1. >
Gauge Settings
> OK > Signal Settings > OK
2. Select the desired signal function: > OK.
Function is activated:
• Parameter Light intensity, set the desired brightness value: > OK
The higher the set value, the higher the luminosity.
3. Repeat step 2. for more menu functions.
4. Exit the menu: , the settings are now made.
Signals
The sound and light signals listed in the table are output in succession, if necessary,
e.g. at the last measured reading of a block (block closure): 1 short beep followed by
a long beep and the light band lights up in green, then in yellow.
Beeps/
beep
Visual signal
probe + gauge
Meaning
1 x short 1 x green Measured reading acquisition, measured
reading is within the specification limits/
above the specification limit when specifi-
cation limit monitoring is activated
1 x short + 1 x long 2 x red Measured reading is outside the specifica-
tion limits/below the specification limit
when specification limit monitoring is acti-
vated
1 x long 1 x yellow Block closure, when automatic block for-
mation is activated
[ ]
To Next Page
Loading...
