FISCHER DELTASCOPE DMP30 - Deleting a Batch

40
Settings for measurement DMP30 / DMP40
To deactivate automatic block formation
1. > Batch Modify > OK > Block Size > OK > Generate autom. > OK.
Parameter is deactivated:
2. Exit menu: , automatic block formation is deactivated.
7.5 Activating/deactivating offset function
You can correct the measured reading by a pre-defined offset value. The actual mea-
sured reading less the offset value is displayed.
Application example: coating thickness measurement on a 2-coating system with
known intermediate coating thickness that is entered as the offset value. Only the
thickness of the top coating is then displayed.
Before you start
 The batch for which you want to make the changes is open in the gauge.
To activate the offset and set the offset value
1. > Batch Modify > OK > Offset > OK > On > OK > set desired offset value > OK
Parameter is activated:
2. Exit the menu: , the settings are now made.
The icon appears in the Measurement view to indicate the active offset func-
tion.
To deactivate the offset function
1. > Batch Modify > OK > Offset > OK > Off > OK
Parameter is deactivated:
2. Exit the menu: , the offset function is deactivated.
[ ]
[ ]
O
[ ]