FISCHER DELTASCOPE DMP30 - Evaluation; 10.1 Batch statistics

76
Evaluation DMP30 / DMP40
10 Evaluation
The gauge provides you with the mathematical calculations, complex and extensive
at times, needed for statistical evaluation of the measured readings from the opened
batch and the measurement blocks when automatic block formation is switched on.
The evaluation refreshes continuously in the background during the measurement.
The statistical characteristic variables of the open batch are displayed in the Statis-
tics menu. If automatic block formation is activated for the open batch, you can also
display the statistical evaluation for each measured reading block. Either the individ-
ual measurements or the block average values are considered and displayed as
measured readings in the statistical evaluation.
10.1 Batch statistics
 Display statistical characteristic variables for all
measured readings of the open batch: > Statis-
tics > OK.
 Display histogram for all measured readings of the
open batch (possible from 5 measured readings):
> Statistics > OK > > Batch Charts > OK > His-
togram > OK.
If no measurement data appear for the class divi-
sion, the display refers to the entire measurement
range of the connected probe.
Description of the characteristic variables, see
page 15
Example of batch statistics
NF/FE
Batch Statistics
n 9 x 274.4
s 2.67 R 8.5
V[%] 1.0 Min 271
Max 280 <LSL 0
>USL 0
BLOCK
[ ]
[ ]