39
DMP30 / DMP40 Settings for measurement
2. Set the specification limit: select specification limit > OK > set desired value >
OK.
Repeat step 2 for the second specification limit, provided you have selected
Both in step 1.
3. Exit the menu: , the settings are now made
In the Measurement view, lines with the entered specification limits appear
above and below the measured reading or a line appears below the measured
reading with the entered limit value.
To deactivate specification limit monitoring
1. > Batch Modify > OK > Limits > OK > Off > OK
Parameter is activated:
2. Exit the menu: , specification limit monitoring is deactivated.
7.4 Activating/deactivating automatic block formation
You can automatically group a predefined number of measured readings into mea-
sured reading blocks. Activate automatic block formation to form a block closure au-
tomatically after a specified number of measured readings during the measurement.
Before you start
The batch for which you want to make the changes is open in the gauge.
The open batch does not contain any measured readings.
To activate automatic block formation and set the desired block size
1. > Batch Modify > OK > Block Size > OK > Generate autom. > OK.
Parameter is activated:
2. Set the block size: Block Size > OK > set desired value > OK.
3. Exit the menu: , the settings are now made.
[ ]
[ ]
To Next Page
Loading...
