21
DMP30 / DMP40
Technical Data
Ways of air reference value acquisition
During measurement, the air reference value is used to reference the zero point
determination. Regular measurement of the air reference value is necessary to
achieve high measurement accuracy. This is done automatically in the measure-
ment mode Single Reading when the probe is lifted off from the surface.
Default in Probe: air value acquisition as factory predefined in probe (Dynamic/
Static)
Dynamic: automatic acceptance of the air value always when the probe is lifted
from the surface, default mode
Static: no automatic acceptance of the air value always when the probe is lifted
from the surface. In this case, the air reference value must be measured man-
ually at regular intervals. This may be useful for measurements in small cavi-
ties or pipes where the minimum lift-off distance of the probe cannot be main-
tained within cavity/pipe.
General Features
Measurement views
Simple: the measured reading with the set measurement unit is displayed only;
additionally with display of the limit values if set
Statistics: the measured reading with tabular measurement statistics
Languages
Many different display languages, beside German and English several other Eu-
ropean and Asian languages
Date & Time
settable
Date and time formats settable (DD.MM.YY or MM/DD/YY and 12 h or 24 h)
To Next Page
Loading...
