FISCHER DELTASCOPE DMP30 - 11.2 Data transfer via Bluetooth

80
DMP30 / DMP40
Data transfer
11.2 Data transfer via Bluetooth
To transfer data using Bluetooth®, you need the special Fischer-Bluetooth stick, in-
cluded in the scope of supply.
Before you start
 The Tactile Suite software program is installed on the PC.
 The Fischer-Bluetooth stick from the scope of supply is ready.
 The battery in the gauge is charged, 31.
 The automatic gauge shutdown function is deactivated, 92.
ATTENTION – interruption to data transfer
Please note that switching off the gauge interrupts data transfer!
To transfer data to Tactile Suite via Bluetooth
1. Insert the Fischer-Bluetooth stick into the gauge:
2. Switch on the gauge:
1.
2.
3. 4.
Fischer-
Bluetooth
stick
7.
5.
6.
[ ]