7
DMP30 / DMP40 Description
Setting values faster
• Measure once on the surface. You can use this value to set the desired value
faster.
• Press and hold the arrow keys or longer.
3.3 Overview of signals
If all signal functions in the gauge are activated, the gauge reports the following
states:
Beeps
Short beep = measured reading acquisition complete, second beep in addition
if the specification limit is violated
Long beep = block closure
Light signals
Specification limit monitoring not active:
Green = measured reading acquisition successful
Specification limit monitoring active:
Red = measured reading outside the specification limits, the measured reading
itself is also displayed in red.
Green = last measured reading is within the specification limits
Gauge vibration
Measured reading acquisition completed, second vibration in addition in case of
a specification limit violation or block closure
3.4 Softkey – icons/codes
Forward, skips the next step in the routine
Back
• Returns to the previous menu page, displayed settings are applied
• Moves the cursor to the left, e.g. when the name is entered
Opens the Measurement view
To Next Page
Loading...
