8
Description DMP30 / DMP40
Calls up the calibration (calibration routine) from the Measurement view
Moves the cursor using the arrow keys
• Moves the selection marking
• Increases/decreases the numerical value displayed
Calls up the Delete function
Opens another menu page
Scrolls, displays the next page
Run
• Confirm the message/information
• Starts the function (e.g. Delete function)
Cancels the setting process and exits the function or returns to the previous
page without saving any changes
CLOSE Sets a block closure when the block statistics are exited; available only
when automatic formation is deactivated
BLOCK Calls up the block statistics for the current measured reading block
OK Confirm
• Confirms the selection/setting/information
• Moves the cursor to the right, e.g. when entering a name
RUN Starts continuous count rate acquisition
STD Calls up the page for entering the nominal value of the calibration foil/cali-
bration standard used
STOP Ends the continuous count rate acquisition
TH Switches to coating thickness display in the count rate Measurement view
(unit of measurement set as in the open batch)
XN Switches to count rate display in the count rate Measurement view
To Next Page
Loading...
