28
Guide DMP30 / DMP40
4 Guide
All relevant settings for measuring the coating thick-
ness of a coated specimen
1
and the measured read-
ings themselves are saved in the gauge in a file.
Such a file is called a batch. In order to measure, you
must assign to the batch a calibration (reference)
that is saved in the connected probe.
In the batch, you define the measurement procedure,
e.g. whether specification limits are to be monitored
during the measurement or whether the measured
readings are to be acquired in measured reading
block groups.
3 steps to the measurement
1. Start-up the gauge
• Insert/charge the battery, 29
• Connect the probe, 33
• Switch on the gauge: press the [ ] key for
approx. 2 s.
2. Open a batch or create a new one
• Open a batch: > Batches > OK > select the
desired batch from the batch list > OK
• Create a new batch, 37
3. Take measurements on the specimen, 46
If the specified precision is not achieved during
the measurement, you must check the calibration, 68.
1. In this Operator's Manual, both a coated part of any shape and size and a surface containing mul-
tiple measuring positions are referred to as a specimen.
NF/FE
Batch 001
No. 110 n 10
46.8 s 1.81
Min 44.9 Max 48.5
x
BLOCK
47.3
µm
i49.0
i44.5
Example of the Measurement
view showing statistics with
set specification limits
OK
Statistics
Batch Modify
Batches
Calibrations
Gauge Settings
NF/FE
Batch 001
Main menu (example: Batch
001 is open)
[ ]
To Next Page
Loading...
