5
DMP30 / DMP40 Limitation of liability
2 Limitation of liability
The manufacturer accepts no liability and no responsibility for the precision, conclu-
sions, and interpretation of the measurement results. Only continuous monitoring of
the measurement devices by the user can guarantee the continued precision of mea-
surements. The manufacturer accepts no liability or responsibility for consequential
damage caused by the use of incorrect measured readings.
3 Description
The gauges of the DMP series measure coating thicknesses easily, quickly, and in a
nondestructive manner. The gauge design with exchangeable probes allows a flexi-
ble use.
This Operator's Manual describes the following gauge models of the DMP series:
DUALSCOPE® DMP40
Coating thickness measurement on ferrous as well as on non-ferrous metal
base materials (NC/FE, NF/FE, NC/NF)
DELTASCOPE® DMP30
Coating thickness measurement on non-ferrous base materials (NC/FE,
NF/FE)
ISOSCOPE® DMP30
Coating thickness measurement on non-ferrous base materials (NC/FE)
Additional information can be found in the data sheet, from page 17
To Next Page
Loading...
