29
DMP30 / DMP40 Rechargeable battery
5 Rechargeable battery
This chapter contains important instructions on handling, changing and charging the
battery.
CAUTION – when handling the battery
Improper handling of the battery can cause the battery to overheat,
leak or burst.
► Use only batteries specified by the manufacturer to operate
this gauge:
Type RRC 1130 (3.8 V, 14.47 Wh, scope of supply)
► Prevent metal objects such as necklaces, rings, etc. from
short-circuiting the contacts.
► Do not continue to use the battery if you notice any changes
such as discoloration, deformation or damage to the outer
casing.
► Replace the battery if it is not charged after the usual charging
time. The usual charging time can be found in the technical
data.
► Do not expose the battery to excessive heat, moisture or direct
contact with water.
► Store the gauge with out the battery when not in use for a long
period of time.
5.1 Changing the battery
Before you start
The gauge is switched off ([ ]).
To Next Page
Loading...
