94
Gauge settings DMP30 / DMP40
14.7 Default settings for unit of measurement and decimal places
You set defaults in the gauge for the unit of measurement and the maximum number
of decimal places. All newly created batches are automatically assigned this these
default variables (Preset Unit and Preset rounding).
To change the unit of measurement
1. > Gauge Settings > OK > More Settings > Preset Unit > OK > select desired unit
of measurement > OK
Unit of measurement is activated:
2. Exit the menu: , the settings are now made.
To set the number of decimal places for the display values
1. > Gauge Settings > OK > More Settings > OK > Preset rounding > OK > select
desired max. number of decimal places > OK
Parameter is selected:
Parameter selection:
• Low: maximum 1 decimal place is displayed 0.9 / 9.9 / 99 / 999 / 9999
• Medium: maximum 2 decimal places are displayed 0.99 / 9.9 / 99.9 / 999 /
9999
• High: maximum 3 decimal places are displayed 0.999 / 9.99 / 99.99 / 999.9
/ 9999
• Navsea: measured readings up to 254 μm (10 mils) are displayed with 1
decimal place, 0.9 / 9.9 / 99.9 / 253.9
2. Exit the menu: , the settings are now made.
14.8 Activating/deactivating lock code
Use the lock code to activate/deactivate the lock function (Lock Calibration) for select-
ed calibrations.
[ ]
[ ]
To Next Page
Loading...
