2
Safety DMP30 / DMP40
1.2 Intended use
The gauge is intended solely for the measurement of coating thicknesses.
The measurement system (gauge and probe) is designed for operation under the fol-
lowing environmental conditions:
Indoor and outdoor operation
Operation outside potentially explosive areas only!
Ambient temperature during operation: 0 … +40 °C (+32 °F … +104 °F)
Operation at altitudes up to 2000 m (6561.7 ft) above sea level
Only accessories approved or recommended by the manufacturer may be connected
to the gauge.
Any further use is not in accordance with the intended use. The risk of damage re-
sulting from this is borne solely by the user!
ATTENTION – Destruction of the gauge due to condensation
If the gauge is moved from a cold environment to a warm environment, conden-
sation can form inside the gauge and damage its electronics. Such extreme
temperature changes occur e.g. in winter between outside (0 °C (+32 °F)) and
room temperature (+22 °C (+71.6 °F)).
► Allow the gauge some time to acclimatize to the ambient temperature
before turning it on and starting a measurement.
1.3 Safety of the electrical equipment
EMC (Directive 2014/30/EU, electromagnetic compatibility)
The gauges of the DMP series comply with the regulations concerning electromag-
netic compatibility. The gauges are designed for battery operation. Mains operation
via travel charger or PC is possible, but not recommended. The guaranteed confor-
mity applies exclusively to battery operation!
To Next Page
Loading...
