83
DMP30 / DMP40 Batch settings
Measurement View
Type of Measurement view set for this batch (Simple, Statistics).
Meas. unit
µm (example)
Block Size
Number of measured readings collected in a block.
Offset
Information about the offset: off or set offset value.
Measure Mode
Information about the set measuring mode: Single Readings, Free Running or Scan
with the set scan parameters
Values rounding
Information about the resolution of the displayed values: number of decimal places
used to display the measured reading and the statistical values.
Save Readings
Information indicating whether this function is activated or deactivated for this batch.
Air Reference
Information indicating how the probe acquires the air value for this batch.
12.2 Changing the unit of measurement for the batch
You can change the unit of measurement for the open batch, as well as its block and
batch statistics.
block and
Before you start
The batch for which you want to make the changes is open in the gauge.
To change the unit of measurement
1. > Batch Modify > OK > Meas. unit > OK > select desired unit of measurement
> OK
Unit of measurement is activated:
2. Have you selected the Own Unit unit of measurement?
• No: Continue with step 3.
[ ]
To Next Page
Loading...
