87
DMP30 / DMP40 Batch settings
12.5 Setting the decimal places for the display values
For the open batch, you can set the number of decimal places for displaying the mea-
sured reading and for the values of the statistical characteristic variables both in the
Measurement view and in the statistical displays.
Before you start
The batch for which you want to make the changes is open in the gauge.
To set the decimal places for the display values
1. > Batch Modify > OK > More Settings > OK > Values rounding > OK > select
desired max. number of decimal places > OK
Parameter is selected:
Parameter selection:
• Low: maximum 1 decimal place is displayed
0.9 / 9.9 / 99 / 999 / 9999
• Medium: maximum 2 decimal places are displayed
0.99 / 9.9 / 99.9 / 999 / 9999
• High: maximum 3 decimal places are displayed
0.999 / 9.99 / 99.99 / 999.9 / 9999
• Navsea:
measured readings up to 254 μm (10 mils) are displayed with 1 decimal
place, 0.9 / 9.9 / 99.9 / 253.9
Measured readings from 254 μm (10 mils) are displayed as an integer, 254
/ 999 / 9999
2. Exit the menu: , the settings are now made.
[ ]
To Next Page
Loading...
