What to do if Alibi memory SD card is not installed in Flintec FT-111 D?
If the Alibi memory SD card is not installed, disable Alibi memory if it is not required. Otherwise, check the Alibi SD card or change the mainboard.
What to do if the weight is too low for Flintec FT-111 D?
If the weight is too low, check the load, as the load cell or instrument could be broken.
What to do if there is a communication error between the display board and main board in Flintec Accessories?
If there is a communication error between the display board and the main board, power off the instrument and reenergize it after 30 seconds. If the issue persists, consider changing the main board.
What to do if there is ADC initialization error in Flintec FT-111 D?
If an ADC initialization error occurs, where the ADC could not initialize at power on due to a malfunction in the ADC or its interface circuitry, power off the instrument and reenergize it after 30 seconds. Also, check the external load cell connection and the load cell connector in the instrument. If problems persist, consider changing the main board or second scale board.
What to do if the power source voltage is less than 9 VDC in Flintec Accessories?
If the power source voltage is less than 9 VDC, check the power supply voltage.
What to do if the load is not stable at calibration of Flintec FT-111 D Accessories?
If the load is not stable at calibration: * Wait until scale become stable. * Check grounding wiring. * Recalibrate the scale. * Change mainboard.
What to do if NVM version error occurs in Flintec Accessories?
If an NVM version error occurs, causing factory defaults to load, press the Enter key if you changed the E2ROM (U13) to load the factory defaults. If you did not change it, consider changing the main board.
What to do if there is Checksum error of calibration coefficients in Flintec Accessories?
If a checksum error of calibration coefficients occurs, check the scale performance. If necessary, recalibrate the scale or change the mainboard.
What to do if there is Check sum error of parameters in Flintec FT-111 D?
If a checksum error of parameters occurs, check the scale performance. If necessary, recalibrate the scale or change the mainboard.
What to do if the load cell output is decreased after loading in Flintec FT-111 D Accessories?
If the load cell output decreases after loading, check the load cell connections and the test weight loading. You may also need to recalibrate the scale or change the mainboard.
Detailed wiring instructions for load cells and other interfaces.
Wiring details for connecting analogue load cells to the FT-111.
Wiring details for connecting digital load cells to the FT-111 D.
Configuration and pinout for the Ethernet TCP/IP interface.
Configuration and pinout for the EtherNET/IP interface.
Details on activating and using the Alibi memory for data recording.
Navigating the programming menu and modifying parameters.
Procedures for performing scale calibration with test weights.
Steps for addressing and configuring digital load cells.
Details on Modbus RTU and TCP/IP communication protocols.
Configuration parameters for the Ethernet TCP/IP interface.
Information on Profibus DP interface, baud rates, and LEDs.
Details on the Profinet interface, LEDs, and configuration.
Information on CANopen network communication, LEDs, and data format.
Information on EtherCAT interface, LEDs, and data format.
Details on CC-Link network communication, LEDs, and configuration.
General| Brand | Flintec |
|---|---|
| Model | FT-111 D |
| Category | Accessories |
| Language | English |
To Next Page
