What to do if the load exceeds the operation range in Flintec Accessories?
If the load exceeds the operation range, check the load and the calibration. It is also possible that the load cell or instrument is broken.
What to do if there is a Checksum error in Flintec FT-111 D?
If a checksum error occurs, check the termination resistors and the DLC connection (RS-485 & Power supply) hardware.
What to do if there is Alibi CSUM error in Flintec FT-111 D?
If an Alibi CSUM error occurs, check the alibi memory records. If necessary, change the Alibi memory SD card or the main board.
What to do if there is ADC output is not changed for the span calibration in Flintec Accessories?
If the ADC output is not changed for the span calibration, recalibrate the scale or change the mainboard.
What to do if there is Clock error in Flintec FT-111 D Accessories?
If a clock error occurs, change the CR2032 battery or the main board.
What to do if there is Wrong SD card at alibi memory in Flintec FT-111 D Accessories?
If the wrong SD card is used at alibi memory, order an Alibi SD card.
What to do if there is Status error of load cell in Flintec Accessories?
If there is a status error of the load cell, change the load cell.
What to do if the weight is out of power on zero range in Flintec FT-111 D Accessories?
Press key to start indication without zeroing and call service.
What to do if there is Alibi memory could not be initialized in Flintec Accessories?
If the alibi memory could not be initialized, check the alibi memory SD card, or change the main board.
What to do if Alibi SD card is not supplied from FLINTEC in Flintec FT-111 D Accessories?
If the Alibi SD card is not supplied from Flintec, install a Flintec Alibi SD card.
Detailed wiring instructions for load cells and other interfaces.
Wiring details for connecting analogue load cells to the FT-111.
Wiring details for connecting digital load cells to the FT-111 D.
Configuration and pinout for the Ethernet TCP/IP interface.
Configuration and pinout for the EtherNET/IP interface.
Details on activating and using the Alibi memory for data recording.
Navigating the programming menu and modifying parameters.
Procedures for performing scale calibration with test weights.
Steps for addressing and configuring digital load cells.
Details on Modbus RTU and TCP/IP communication protocols.
Configuration parameters for the Ethernet TCP/IP interface.
Information on Profibus DP interface, baud rates, and LEDs.
Details on the Profinet interface, LEDs, and configuration.
Information on CANopen network communication, LEDs, and data format.
Information on EtherCAT interface, LEDs, and data format.
Details on CC-Link network communication, LEDs, and configuration.
General| Brand | Flintec |
|---|---|
| Model | FT-111 D |
| Category | Accessories |
| Language | English |
To Next Page
