Limitorque QX Electronic Actuator FCD LMENIM3306-06 – 07/14
4
4.16 Change Analog Out 60
4.16.1 APT Polarity Option 62
4.16.2 ATT Polarity Option 63
4.17 Remote Mode 63
4.18 Local Control 64
4.18.1 LED Customization 64
4.19 ESD (Emergency Shutdown) Overrides 64
4.19.1 ESD Override 65
4.19.2 Inhibit 65
4.19.3 Local Command 65
4.19.4 Stop 65
4.19.5 Jammed Valve* 65
4.19.6 Lost Phase* 66
4.19.7 Overtorque* 66
4.19.8 Motor Thermostat 66
4.19.9 Oil Over Temperature 66
4.19.10 Two-Speed Timer 66
4.19.11 Network ESD 67
4.19.12 Torque Switch Timer 67
4.20 Inputs 67
4.20.1 Input Standard Remote Control 67
4.20.2 Status 68
4.20.3 Custom Input Mode #1 – Momentary ESD/PSESD (Optional) 68
4.20.4 Custom Input Mode #2 – Momentary ESD/CSE (Optional) 71
4.20.5 Custom Input Mode #3 – ESD Time Delay Relay 71
4.20.6 Custom Input Mode #4 – Multi-Position Mode (Optional) 72
4.21 Monitor Relay 73
4.22 Diagnostic Reset 74
4.23 TAG Number 75
4.24 LCD Contrast 76
4.25 Motor Thermostat 76
4.26 Change Valve Data 76
4.27 Change Port 77
5 Troubleshooting 78
5.1 View Diagnostics Routine 79
5.2 Troubleshooting Problems/Corrective Action 79
5.2.1 Actuator Fails to Operate 79
5.2.2 Jammed Valve Detected 80
5.2.3 Actuator Operates but Does Not Drive Valve 80
5.2.4 Valve Does Not Seat Correctly 80
5.2.5 Status Messages 81
5.3 View Diagnostics 83
5.4 View Hardware Status 84
5.5 View Motor Status 85
5.6 View Power Supply 85
5.7 View Identification 85
5.8 View Torque Profile 86
5.9 View Operation Log 86
5.10 View DNET Status? 88
6 Maintenance 90
6.1 Lubrication 90
6.1.1 Oil Capacities 90
6.1.2 Checking Oil Level 90
7 Regulatory Information 91
7.1 Specific Conditions for Safe Use — Atex/Cenelec/IECEx Applications 94
7.2 Statement of Compliance with Applicable European Directives 94
To Next Page
Loading...
Need help?
General
