Limitorque QX Electronic Actuator FCD LMENIM3306-06 – 07/14
88
5.10 View DNET Status?
This selection permits the User to view pertinent information that summarizes the status of the DeviceNet option board
Figure 5.9 – View DNET status
YES YES
NO NO
VIEW
DNET STATUS?
YES
NO
VIEW
MODULE STATUS?
YES
NO
OFF - NEXT?
YES
NO
NOT ONLINE -
NEXT?
(OPERATIONAL)
(STANDBY)
(RECOV FAULT)
(UNRECOV FAULT)
(ONLINE)
(CONNECTED)
(CONN TIMEOUT)
(COMM FAULT)
VIEW
NETWORK STATUS?
VIEW MODULE STATUS?
Answer “YES” to determine status of individual DN board within the actuator.
Configuration choices are:
“OFF” = Board installed but turned off
“STANDBY” = The device needs commissioning due to configuration missing, incomplete or incorrect.
“RECOVERABLE FAULT” = Conditions that can cause this event are e.g. communication fault, power fault or Limiguard
fault of the SMT Main Board. Device may need resetting.
“UNRECOVERABLE FAULT” = Internal Diagnostic Fault detected e.g.
• Receive Queue Overrun
• Transmit Queue Overrun
• CAN Controller Overrun
Device may need replacing.
“SELF TESTING” = The device is in self-test mode.
VIEW NETWORK STATUS?
Answer “YES” to determine status of DN network.
“NOT ON LINE” = Device is not on-line.
• The device has not completed the self-test yet.
• The device may not be powered, look at Module Status Display.
“ONLINE” = Device is on-line but has no connections in the established state.
• The device has passed the SELF test, is on-line, bus has no established connections to other nodes.
• For a Group 2 Only device it means that this device is not allocated to a master.
• For a UCMM capable device it means that the device has no established connections.
“CONNECTED” = The device is on-line and has connections in the established state.
To Next Page
Loading...
Need help?
General
