Flytec 6030 - Page 57

© Flytec USA, 2007 – 2014 Printed on 100% post-consumer recycled paper
57
Setting Description Reference Factory Default
Vario
Vario response delay
Vario responsiveness - range 0 (slow) to 4 (fast)
3.1.2
2
Digital vario mode
Averager (INT) or netto vario; averager period (1–30
sec)
3.1.2
INT; 1 sec
Last thermal threshold
Minimum strength of thermal to be tracked by last
thermal feature (100–600 ft/min)
4.4
197 ft/min
Thermal averager
Time interval over which climb rate is averaged in the
previous thermal (0.5–10 min)
3.1.3
20 = 10 min
Acoustic vario
Customize sound
Frequency of ascent tone, modulation, frequency of
sink tone, acoustic integrator, pitch
3.6
1200 Hz; Mod = 5; 700
Hz Damp = 8;Pitch = 3:
Lift audio threshold
Threshold for ascent tone (0–80 ft/min/ 0–0.4 m/sec)
3.6
4 = 0.04 m/sec (8
ft/min)
Near thermal tone
Set lower threshold for nascent thermal tone;
enable/disable tone; set beep/pause ratio for tone
-90ft/min, no, 20%
Sink tone threshold
Descent rate required to sound sink alarm (10–2000
ft/min)
3.6
160 ft/min (0.8 m/sec)
Speed
Speed mode
True or Indicated air speed;
Speed range upper 19–54 mph; lower 12–37 mph
3.4.1
True air speed;
upper speed range
Pitot correction
Sensor on/off; Pitot sensor 90 to 150 %
3.4.1
True air speed;
upper speed range
Vane Wheel correction
Vane wheel 70 to 150 %
3.4.1
True air speed;
upper speed range
Stall speed
Speed threshold and altitude limit
3.4.1
0 mph, 0 ft
TEC
Total energy compensation range 0–99%
3.4.5
65%
Recording
Recording mode
Always, full auto, semi-auto start/end of flight recording
Ground speed & altitude change for Flight Acceptance
6.1
Full auto
10kn/h; 20m
Recording interval
Time interval per track log point (1–60 sec)
6.1
10 sec = 48 hrs
McCready
Delay for McCready audio after leaving lift, acoustic
dead band in ft/min (m/sec)
3.5
7 sec; ±100 ft/min
CTR Alarm
Acoustic alarm when within warning distance to loaded
airspace
7
No
Polar data
Use polar set 1 or 2, sink rate/air speed pair, altitude of
data
12.4
25 mph @ 197 ft/min;
47 mph @ 630 ft/min;
@ 1000’
Map Orientation
North up or course up
4.3
0= Course up
Auto Zoom C-Route
Set proximity to cylinder and mode for auto zoom
5.4.1.1
0=auto zoom off: 150m
Pilot Name
Enter pilot name
2.3.2
Not set
Glider type
Glider class for OLC (HG Rigid Wing or HG Flexible
Wing or Paraglider)
2.3.2
Not set
Glider Id
Your ham radio call sign for OLC
2.3.2
Not set
It is always possible to reset all of the user settings back to the factory settings using Menu>Clear/Initialize
memory>Initialize EEPROM. Important! All flight records, waypoints and routes will be deleted if you reset the
unit.