Fractal FM9 - SAVING CHANGES

47
5 PRESETS
SAVING CHANGES
After editing a preset, you may want to save the results.
Every preset in the FM9 can be modied. There are no permanent presets.
When you change a preset in any way, the front panel "EDITED" LED lights until you STORE or load a new preset.
TO STORE A PRESET…
 Press STORE to show the STORE page.
 Turn the VALUE wheel or B knob if you wish to save to a different location.
 Press ENTER to display “Do you want to overwrite the Preset?”
 Press ENTER again to conrm, or EXIT to cancel.
 The message “SAVED!” is shown when saving is complete.
TO CHANGE PRESET OR SCENE NAMES…
The FM9 has 512 preset memory locations. You can edit the name of any preset while storing.
 Press STORE to show the STORE page.
 NAV down once to the PRESET line.
 Turn the B knob to move the cursor.
 The C knob selects UPPER CASE letters.
 The D knob selects lower case letters.
 The E knob selects numbers.
 The VALUE knob selects ALL characters, including symbols.
 You can use up to 31 characters in a preset name.
 You can also NAV to any Scene name to edit it in the same way.
 Press ENTER to Store, then press ENTER again to conrm.
 The message “SAVED!” is displayed and the new location (if any) is loaded.
Scene naming is a powerful capability. Aside from stating what a specic scene is
intended for, the names of unused scenes can be used for short notes or reminders.