112
Process parame-
ters for Synchro-
Pulse
The following process parameters can be set for SynchroPulse welding:
(1) Synchropulse
To activate/deactivate SynchroPulse
Unit -
Setting range off / on
Factory setting off
(2) Wire feed speed
For setting the wire speed and therefore the welding power for SynchroPulse
Unit m/min (ipm)
Setting range for example: 2 - 25
(depending on wire speed and welding characteristic)
Factory setting 5.0
(3) Delta wire feed
For setting the Delta wire feed:
in SynchroPulse, the set wire speed is alternately increased/reduced by the Delta wire
feed. The parameters concerned adapt themselves to this wire speed acceleration/delay
accordingly.
Unit m/min (ipm)
Setting range 0.1 - 6.0 (5 - 235)
Factory setting 2.0
(4) Frequency F
For setting the frequency for SynchroPulse
Unit Hz
Setting range 0.5 - 3.0
Factory setting 3.0
(5) Duty Cycle (high)
For weighting the duration of the higher operating point in a SynchroPulse period
Unit %
Setting range 10 - 90
Factory setting 50
(6) Arc-length correction high
For correcting the arc length for SynchroPulse in the upper operating point (= average
wire speed plus Delta wire speed)
Unit -
Setting range -10.0 - +10.0
Factory setting 0.0
- short arc
0 uncorrected arc length
+ longer arc
To Next Page
Loading...
