Fronius TPS 320i - Status Bar; Status Bar - Current Limit Reached

46
Status bar
The status bar is divided into segments and contains the following information:
(1) Current welding process
(2) Current operating mode
(3) Current welding program (material, shielding gas, characteristic and wire diameter)
(4) Current logged-on user (with active user management)
or
the key symbol when the power source is locked (e.g. when the "locked" profile/
role is active)
(5) Time and date
Status bar – Cur-
rent limit reached
If the characteristic-dependent current limit is reached while MIG/MAG welding, a corre-
sponding message appears in the status bar.
For detailed information, select the status bar
The information appears.
Select "Hide information" to exit
Reduce the wire speed, welding current, welding voltage or material thickness
or
Increase the distance between the contact tip and the workpiece
Further information on the current limit can be found in the Troubleshooting section on
page 193.
(1) (2) (3) (5)(4)
Current limit exceeded!
1
1
2
3