Fronius TPS 320i - Job Welding - Retrieving a Job

81
EN
Enter a job name
Select "OK" and confirm the job name / press the adjusting dial
The name is saved and a confirmation that the job has been stored is displayed.
To exit, select "Finish" / press the adjusting dial
Job welding - re-
trieving a job
Select "Welding process"
Select "Process"
Select "Job mode"
Job mode is activated.
"Job welding" and the data from the most recently retrieved job are displayed.
Select "Job welding"
Turn the adjusting dial and select "Job number" (white background)
To select the desired job, press the adjusting dial (blue background)
Turn the adjusting dial to select the desired job number (blue background)
The name of the selected job is displayed above the actual value display.
Press the adjusting dial and accept the selected job number (white background)
Start welding
IMPORTANT! "Job number" is the only parameter that can be altered in Job mode; all the
others are read-only.
6
7
8
NOTE! Before retrieving a job, make sure that the welding system has been in-
stalled and set up for the job.
3
1
2
1
2
3
4
5
6
7
8
9