Fronius TPS 320i - Minimum equipment needed for welding task

49
EN
Minimum equipment needed for welding task
General Depending on which welding process you intend to use, a certain minimum equipment lev-
el will be needed in order to work with the power source.
The welding processes and the minimum equipment levels required for the welding task
are then described.
MIG/MAG gas-
cooled welding
- Power source
- Grounding (earthing) cable
- MIG/MAG welding torch, gas-cooled
- Shielding gas supply
- Wire-feed unit
- Interconnecting hosepack
- Wire electrode
MIG/MAG water-
cooled welding
- Power source
- Cooling unit
- Grounding (earthing) cable
- MIG/MAG welding torch, water-cooled
- Shielding gas supply
- Wire-feed unit
- Interconnecting hosepack
- Wire electrode
MIG/MAG auto-
mated welding
- Power source
- Robot interface or field bus connection
- Grounding cable
- MIG/MAG robot welding torch or automatic MIG/MAG welding torch
A cooling unit is also required with water-cooled robot or machine welding torches.
- Gas connection (shielding gas supply)
- Wirefeeder
- Interconnecting hosepack
- Wire electrode
Manual CMT
welding
- Power source
- Standard, Pulse and CMT welding packages enabled on the power source
- Grounding cable
- PullMig CMT welding torch incl. CMT drive unit and CMT wire buffer
IMPORTANT! For water-cooled CMT applications, a cooling unit is also required!
- OPT/i PushPull
- Wirefeeder
- CMT interconnecting hosepack
- Wire electrode
- Gas connection (shielding gas supply)