Fronius TPS 320i - Welding Parameters for MIG;MAG Standard Synergic Welding and LSC Welding

75
EN
Welding parame-
ters for MIG/MAG
standard syner-
gic welding and
LSC welding
The following welding parameters for MIG/MAG standard synergic welding and LSC weld-
ing can be set and displayed by selecting the "Welding" menu button:
Current
1)
Unit A
Setting range Depends on the welding process and welding program selected
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Voltage
1)
Unit V
Setting range Depends on the welding process and welding program selected
Before the start of welding, the device automatically displays a standard value based on
the programmed parameters. During welding, the actual value is displayed.
Material thickness
1)
Unit mm in.
Setting range 0.1 - 30.0 mm
2)
0.004 - 1.18
2)
Feeder command value
1)
for setting a harder, more stable arc
Unit m/min ipm.
Setting range 0.5 -max.
2)
19.69 -max.
2)
Arc length correction
For correcting the arc length, which is preset by the characteristic or the synergic pro-
gram;
Setting range -10 - +10
Factory setting 0
- Shorter arc length
0 Neutral arc length
+ Longer arc length
Pulse/dynamic correction
For influencing the short-circuiting dynamic at the instant of droplet transfer
Setting range -10 - +10
Factory setting 0
- Harder, more stable arc
0 Neutral arc
+ Soft, low-spatter arc