Fronius TPS 320i - Welding Parameters for MIG;MAG Standard Manual Welding; Explanation of Footnotes

76
Welding parame-
ters for MIG/MAG
standard manual
welding
The following welding parameters for MIG/MAG standard manual welding can be set and
displayed by selecting the "Welding" menu button:
Explanation of
footnotes
1) Synergic parameter
When a synergic parameter is changed, the synergic function automatically chang-
es all other synergic parameters to match.
The real setting range depends on power source and wire feeder used and on the
welding programm.
2) The real setting range depends on the welding program.
3) The maximum value depends on the wire feeder used.
Voltage
Unit V
Setting range Depends on the welding process and welding program selected
Dynamic
For influencing the short-circuiting dynamic at the instant of droplet transfer
Setting range 0 - 10
Factory setting 0
0 Harder, more stable arc
10 Soft, low-spatter arc
Feeder command value
for setting a harder, more stable arc
Unit m/min ipm.
Setting range 0.5 -max.
2)
19.69 -max.
2)