Fronius TPS 320i - Process Parameter for Wire End Monitoring

123
EN
Select "Wire stick work piece"
The overview "Wire stick workpiece - setup menu" is displayed.
Turn the adjusting dial and select the desired parameter
Press the adjusting dial (blue background)
Turn the adjusting dial and change the value of the parameter (blue background)
Wire stick on workpiece = ignore:
Wire stick monitoring on the workpiece is deactivated.
Wire stick on workpiece = error (activated):
The welding process will be interrupted if the wire sticks on the workpiece.
Factory settings = ignore
Select "OK" to confirm the settings
Process parame-
ter for wire end
monitoring
Select "Process parameters"
Select "Components & Monitoring"
An overview of the process parameters for components and monitoring is displayed:
3
4
5
6
7
2
1
1
2