127
EN
Further information on optimising jobs can be found in the Welding mode section, under
Job Mode on page 85.
Process parame-
ters for correction
limits
The following process parameters can be set for the job correction limits:
Limit monitoring
(only in conjunction with the OPT/i Limit Mon-
itoring option)
See page 128
- Voltage set value
- Lower voltage limit
- Upper voltage limit
- Max. duration of voltage deviation
- Current set value
- Lower current limit
- Upper current limit
- Max. duration for current deviation
- Wire speed set value
- Lower wire speed limit
- Upper wire speed limit
- Max. duration of wire stick deviation
- Response to violation of limit values
Components See page 117
- Feeder inching speed
Power
Upper power correction limit
For setting the upper power correction limit for a job
Unit %
Setting range 0 - 20
Factory setting 0
Lower power correction limit
For setting the lower power correction limit for a job
Unit %
Setting range -20 - 0
Factory setting 0
Arc length correction
Upper arc length correction limit
For setting the upper arc length correction limit for a job
Unit -
Setting range 0.0 - 10.0
Factory setting 0
To Next Page
Loading...
