Fronius TPS 320i - Setting Process Parameters for Arc Break Monitoring

119
EN
Select "system adjust"
If system calibration is required, the system calibration wizard starts. The first step in the
system calibration wizard is displayed:
Follow the displayed instructions
To move to the next step in the wizard, select "Next" / press the adjusting dial
When system calibration has been completed successfully, a confirmation to this effect is
displayed.
To close the system calibration wizard, select "Finish" / press the adjusting dial
Setting process
parameters for
arc break moni-
toring
Select "Process parameters"
Select "Components & Monitoring"
3
3
4
5
6
2
1
1
2