Fronius TPS 320i - Easyjob Mode; General; Activating Easyjob Mode

77
EN
EasyJob mode
General If EasyJob mode has been activated, 5 additional buttons appear on the display. These
enable up to 5 operating points to be saved at the touch of a button.
The current welding settings are saved.
Activating Easy-
Job mode
Select "Defaults"
Select "View"
Select "EasyJobs"
The overview to activate/deactivate EasyJob mode is displayed.
Select "EasyJobs on"
Select "OK"
EasyJob mode is activated and the default settings are displayed.
Select "Welding"
Five "EasyJob" buttons are displayed for the welding parameters.
3
1
2
1
2
3
4
5
6