Fronius TPS 320i - Page 126

126
Weld-Start / Weld-End See page 100
- Starting current
- Start arc length correction
- Starting current time
- Slope 1
- Slope 2
- Final current
- End arc length correction
- SFI
- SFI HotStart
- Wire withdrawal
Process control See page 103
- Penetration stabilizer
- Arc length stabilizer
SynchroPulse See page 112
- SynchroPulse
- Delta wire feed
- Frequency
- Duty cycle (high)
- Arc length correction high
- Arc length correction low
Process mix See page 114
- Upper power time correction
- Lower power time correction
- Lower power correction
Gas-Setup See page 102
- Gas pre-flow
- Gas post-flow
- Gas set value
- Gas factor
Jobslope See page 128
- Jobslope
Documentation See page 147
- Sampling rate
off / 0.1–100.0 s
Factory setting off